Drum Flow

Malheureusement, cette page n'est actuellement pas encore disponible en français. Nous ne pouvons vous transmettre cette information qu'en anglais pour le moment. Merci de votre compréhension.

All-in-one Drum Processing Suite

Harrison Drum Flow enhances your drum sound, providing punch, detail, and attack without compromising nuance, clarity, and warmth. This complete drum processing solution lets you sculpt your drums with precision, adding personality, dynamics, and expression. With six customizable modules, you can modify drum character, add sub-tones, and apply compression, EQ, and gate—all in one interface. Drum Flow is the ultimate plugin for pro audio engineers, offering control over every aspect of your drums, making them stand out in any mix.

Key Features

• Transient waveform and EQ displays
• Expander/Gate tightens drum sound and removes bleed from nearby drum mics
• Processing elements separated into easy-to-use module controls
• Master controls consisting of input, output and routing sections
• Wet and Dry level faders

Details

• Drum Character: The Drum Character is an EQ that detects the transients of drum hits and allows you to EQ their Attack and Tail ranges separately.

• Expander/Gate: The Expander/Gate is a dynamics processor that attenuates signals below a set threshold. This is useful for removing unwanted parts of a signal that were picked up due to microphone bleed.

• Signal Generator: The Signal Generator offers a convenient way to enhance drum hits with various types of synthesized signals, such as white noise on a snare or a low-frequency sine wave on a kick. The generated signal is fed through a gate which is keyed off of the main input allowing the signal to be triggered on drum hits. The generated signal can then be blended with the main input signal in parallel using the Wet and Dry faders.

• Compressor: The Compressor is based on the Harrison Mixbus channel strip compressor with the addition of Attack and Release controls.

• 32 Channel EQ: The 32C Channel EQ is modeled after the analog EQ found on the Harrison 32C channel strip. It has four bands with Frequency and Gain controls, optional high & low shelf filters, and an Output Trim control.

• Filters: The Filter module contains a Low-Pass Filter (LPF) and a High-Pass Filter (HPF) with variable slopes. Set the corner frequencies of the Filters by adjusting their Frequency knobs or by typing values directly in to the corresponding Frequency control labels.

• Module Controls: The processing elements are separated into modules which can each be individually bypassed, soloed, and reset using the following controls on each module’s top bar. The Reset button resets all of a module’s parameters to their default states. The Solo button bypasses all processing outside of the module being soloed except for master controls (polarity, input and output trim). This allows individual modules to be auditioned exclusively without hearing the effects of any of the other modules. The In button toggles the enablement of each module. If disabled, a module’s processing is bypassed and its effects will not be heard.

• Master Control Section: The master controls consist of the Input, Output and Routing sections at the bottom of the plug-in editor. The controls in these sections allow you to invert the input polarity, adjust the input & output trim, and set the routing order between processing elements.